Please note that only SECURE access methods are enabled by default, so we need to use HTTPS for WEB access, SSH or Direct console for CLI access.ĭefault passwords for ADMIN access is “manager/manager” Once the address is defined then launch a HTTPS: session to the address that was defined. Once IP addresses have been assigned one can access to the configuration system, this section covers WEB access. You could also use option “9” to reset all configurations to factory default and the initial IP address of the DX940e would be 192.168.1.2.
Simply use Option 2: to define the initial IP address, then Option b: to boot.
*** Hold down SPACE to stop boot process ***ģ: Install Initial Software Image from FTP ServerĤ: Install Initial Software Image via TFTPĥ: Install Initial Software Image via XMODEM Using a PC Terminal application such as Putty or TeraTerm and connect to the dedicated CONSOLE port (38,400 bps, no parity, 8 data bits and 1 stop bit) using a standard DB9 cross over cable (supplied with the equipment) and holding down the SPACE bar after a DX940e power cycle. If you can’t access the DX940e via the Ethernet port, because its address is unknown, then the IP address can be reset via the Console port BOOT application. So for a DX940e connect your PC initially to E6. Please also note that all ports on a factory default setting will be disabled with the exception of the highest Ethernet port number. If this is a new unit the factory default IP address is 192.168.1.2. Access to the WEB interface can be achieved using a WEB browser.
The initial access to DX940e configuration system can be accessed by direct connection to the units console connection, or via an IP based connection using Telnet or SSH.
This example steps through the various configuration screens to setup a SCADA application using a DX940e’s at both the headend and remote sites using Verizon MPLS service offering.įor redundancy, each Control center has simultaneous connections to each remote serial attached RTU and employs 元 VPN tunnels for security.Ĭonfiguration Information used in this example:Īccessing the DX940e Configuration system